Applied Sciences, Vol. 13, Pages 3543: The Effect of Cutting Tool Geometry on Surface Integrity: A Case Study of CBN Tools and the Inner Surface of Bearing Rings

Applied Sciences, Vol. 13, Pages 3543: The Effect of Cutting Tool Geometry on Surface Integrity: A Case Study of CBN Tools and the Inner Surface of Bearing Rings

Applied Sciences doi: 10.3390/app13063543

Authors: Lenka Cepova Robert Cep Leszek Chalko Stepanka Dvorackova Miroslav Trochta Miroslaw Rucki Libor Beranek Ondrej Mizera Volodymyr Chyshkala

In this paper, a practical issue of the application of cubic boron nitride (CBN) cutting tools for the machining of steel 100Cr6 thin-walled bearing rings is addressed. Three geometries of the commercially available CBN cutting inserts were tested at different machining parameters. The effect of geometry was assessed in terms of surface integrity, considering 2D profile parameters, 3D topography of the surface, and residual stresses in the surface layer. The results were sometimes contradictory, since the same cutting inserts provided the largest and the lowest values of the topography parameters, dependent on different cutting conditions. In general, CBN cutting inserts with XCEL geometry ensured the smallest profile parameters Ra and Rz, and the spatial parameters of Smr1 exhibited the largest values among all tested tools, suggesting reduced wear resistance. Residual stresses analysis did not reveal any inacceptable or potentially dangerous surface layer state after machining.