1 year ago
28
Crystals, Vol. 13, Pages 532: Numerical and Experimental Analysis of the ZFC Heat Release from a YBCO Bulk and Validation of YBCO Thermal Parameters
Crystals doi: 10.3390/cryst13030532
Authors: António J. Arsénio Costa João F. P. Fernandes Rui Melicio Carlos Cardeira Paulo J. Costa Branco
This article presents results from a simple experimental methodology used to determine the amount of heat transferred from an yttrium barium copper oxide (YBCO) bulk to liquid nitrogen (LN2) and LN2 consumption during the process of zero-field cooling (ZFC). The thermal power can be determined from the YBCO bulk temperature variation, which is difficult to measure with accuracy. In this procedure, the thermal power from the YBCO bulk to LN2 is determined from the measured rate of LN2 evaporation, considering the LN2 latent heat. To reduce the influence of room temperature heating and make the LN2 mass variation depend as much as possible on the heat released from the YBCO bulk, a step transient from room temperature into the LN2 is performed. The precision of results is determined from the rate of LN2 evaporation due to room temperature heating with the bulk already cooled by ZFC. The temperature evolution at the bulk lateral surface where the heat transfer is higher is also measured. The results from experimental measurements are compared with 3D finite element analysis (FEA) numerical results. The obtained evolutions of the temperature and thermal power from the YBCO bulk are used to validate YBCO thermal parameters, such as thermal conductivity and specific heat capacity at constant pressure. The YBCO bulk equivalent heat capacity and thermal resistance are determined by analyzing the equivalent first-order thermal lumped parameter circuit based on the obtained evolutions in time of the YBCO temperature and heat transferred to the LN2. The characteristics of dependence of the YBCO thermal resistance and heat capacity with temperature are obtained by correlating their time evolutions with the bulk average temperature evolution in time. The YBCO-specific heat capacity at constant pressure is then calculated by dividing the obtained bulk heat capacity by the bulk mass. The YBCO thermal conductivity is calculated from the obtained thermal resistance considering an equivalent bulk section and length toward the main direction of heat flux.
