Forests, Vol. 15, Pages 2211: Discolouration and Chemical Changes of Beech Wood After CO2 Laser Engraving

Forests, Vol. 15, Pages 2211: Discolouration and Chemical Changes of Beech Wood After CO2 Laser Engraving

Forests doi: 10.3390/f15122211

Authors: Jozef Kúdela Ivan Kubovský Michal Andrejko

This study evaluated the influence of infrared laser radiation produced by a CO2 laser, performing under different engraving parameters, on the colour changes and chemical composition of a beech wood surface. The results showed that the lightness clearly decreased with increasing laser power and density. At the highest laser power and the highest raster density, the ΔL* value was 51.3. The values of coordinates a* and b* moderately increased up to a raster density of 5 mm−1; then, with a subsequent raster density increase, the values of these coordinates decreased again. However, the coordinate values were positive in all cases. Even the lowest laser power and raster density resulted in conspicuous discolouration or even a completely new colour compared to the original (ΔE = 10) of the beech wood surface. Further increases in the laser power and raster density resulted in progressively pronounced colour differences and a darker brown colour of the surface. The ATR-FTIR chemical analysis of the beech wood surface revealed that discolouration was mainly caused by heat-induced processes associated with the degradation of carbonyl groups (C=O) in lignin and hemicelluloses. The splitting of C=O bonds induced changes in the content of chromophores responsible for the natural wood colour and for the engraving-related discolouration. The study demonstrates that the amount of energy supplied onto the wood surface by a laser beam using diverse combinations of radiation parameters can be represented by a single variable: the total irradiation dose. The functional relation detected between this variable and the colour differences may serve as a basis for using a controlled laser beam for targeted wood surface discolouration to improve the quality of patterns transferred onto a wood surface. Knowledge of this relation will enable the targeted setting of the laser parameters during engraving so that the laser beam can be used as a tool for transferring high-quality patterns onto wood surfaces.