Micromachines, Vol. 14, Pages 257: High-Efficiency 3D-Printed Three-Chamber Electromagnetic Peristaltic Micropump

Micromachines, Vol. 14, Pages 257: High-Efficiency 3D-Printed Three-Chamber Electromagnetic Peristaltic Micropump

Micromachines doi: 10.3390/mi14020257

Authors: He Chen Xiaodan Miao Hongguang Lu Shihai Liu Zhuoqing Yang

This paper describes the design and characteristics of a three-chamber electromagnetic-driven peristaltic micropump based on 3D-printing technology. The micropump is composed of an NdFeB permanent magnet, a polydimethylsiloxane (PDMS) film, a 3D-printing pump body, bolts, electromagnets and a cantilever valve. Through simulation analysis and experiments using a single chamber and three chambers, valved and valveless, as well as different starting modes, the results were optimized. Finally, it is concluded that the performance of the three-chamber valved model is optimal under synchronous starting conditions. The measurement results show that the maximum output flow and back pressure of the 5 V, 0.3 A drive source are 2407.2 μL/min and 1127 Pa, respectively. The maximum specific flow and back pressure of the micropump system are 534.9 μL/min∙W and 250.4 Pa/W, respectively.